Concrete Plasticizer – Capcoplast PN10

Plastit PN10 is a chloride free water reducing admixture based on selected sugar-reduced lignosulphonates. It is supplied as a brown solution which instantly disperses in water. Plastit PN10 disperses the fine particles in the concrete mix, enabling the water content of the concrete to perform more effectively and improving the consistency of the concrete. This produces higher levels of workability for the same water content, allowing benefits such as water reduction and increased strengths to be taken

Download technical file

Properties And EffectsA

Allows specified strength grades to be met at reduced cement content or increased workability Water reduction significantly improves compressive strengths at all ages and enhances durability through the production of low permeability concrete Minimizes the risk of segregation and bleeding and assists in the production of a dense, close textured surface, improving durability Chloride free, safe for use in prestressed and reinforced concrete

Applications

To improve the effectiveness of the water content of a concrete mix- At higher dosages to provide a cost effective means of reducing concrete permeability and thereby reducing water penetration-

Scope and Method of Use

The optimum dosage of Plastit PN10 to meet specific requirements should always be determined by trials using the materials and conditions that will be experienced in use. The normal dosage range is 0.5 to 1.5 kg/100 kg of cementitious material, including PFA, GGBFS and microsilica.

Physical and Chemical Properties

Appearance Brown Liquid
Specific gravity 1.12 gr/cm3 at 20°C
Chloride Nil to BS5075
Air entrainment Typically less than 2% additional air is entrained at normal dosages.
Alkali content Typically less than 5.0 g. Na2o equivalent/litre of admixture. A fact sheet on this subject is available.

Maintenance And Safety

Packaging Plastit PN10 is available in 20 kg containers and 240 kg drums Storage Plastit PN10 has a minimum shelf life of 12 months provided the temperature is kept within the range of 5°C to 35°C. Should the temperature of the product fall outside this range then contact CAPCO for advice. Freezing point: Approximately -3°C

Concrete Plasticizer – Capcoplast PN10

— Our mission is to improve the quality of concrete —