Tile Adhesive / Powder / with high adhesion and sealing properties (Tilex V2)
Tilex V2 is a tile adhesive product based on Portland cement improved by a polymer. This product will be resistant to moisture after drying with respect to the used polymers in the product.
This product is produced based on the requirements of the disperse grade of the Iran National Standard No.12492-1. Also, this product meets the requirements of the EN 12004-1 Standard.
The amount of using Tilex V2 is 2 to 4 kg per 1 square meter depending on the condition of the surface beneath the work (The porosity and roughness).
Surface preparation: The desired surface must be cleaned from contaminations like dust, oil, and other dirt.
Mixing: Mix each 20 kg powder with 4.5 to 5.5 liters of water and continue mixing to reach a uniform and homogenous paste. Finally, rub the adhesive paste on the tile with a grooved chisel on the surface. The Tilex V2 must be used within 60 minutes after mixing with water. Also, the installation of tile on the surface should be accomplished within 20 minutes. The temperature beneath the work must be 5 to 40˚C for installation. Joint the tiled surface 24 hours after the process is finished.
Note:
The subgrade of implementing tiles and the instruction to apply the adhesive on it must be in a way that at least 60% of the back of the tile is covered with adhesive paste.
