Concrete and Tile Adhesives-Tilex® V100

The amount of using the Tilex V100 is 2 to 4 kg per 1 square meter depending on the condition of the surface beneath the work (The porosity and roughness).

1. Surface preparation: The desired surface must be cleaned from contaminations like dust, oil, and other dirt.
2. Mixing to implement on the floor: Mix each 20 kg powder with 4.5 to 5.5 liters of water and continue mixing to reach a uniform and homogenous paste. Finally, rub the adhesive paste on the tile with a grooved chisel on the surface. The Tilex V100 must be used within 60 minutes after mixing with water. Also, the installation of tile on the surface should be accomplished within 20 minutes. The temperature beneath the work must be 5 to 40˚C for installation. Joint the tiled surface 24 hours after the process is finished.

Note:

• The thickness of the adhesive must not exceed 3 mm after installation on the wall.
• The subgrade of implementing tiles and the instruction to apply the adhesive on it must be in a way that at least 60% of the back of the tile is covered with adhesive paste.